{"product_id":"priekabos-apsvietimo-modulis-piair-etk-7-01-7-kontaktu-lenkiskas","title":"Priekabos apšvietimo modulis PiAir ETK 7.01, 7 kontaktų, lenkiškas","description":"\u003ch2\u003eTrumpai apie prekę\u003c\/h2\u003e\u003cp\u003ePrekė: Priekabos apšvietimo modulis PiAir ETK 7.01, 7 kontaktų, lenkiškas. Kategorija: Laidai ir lizdai.\u003c\/p\u003e\u003cul\u003e\u003cli\u003e\n\u003cstrong\u003eGamintojas:\u003c\/strong\u003e PiAir\u003c\/li\u003e\u003c\/ul\u003e\u003cp\u003eThe device controls the lighting of the trailer through information taken from the rear lamps of the car.\u003c\/p\u003e\u003cp\u003eThe device is designed to work with ordinary bulbs and LED lamps in the trailer.\u003c\/p\u003e\u003cp\u003eThe device also works with a single-fiber installation (PWM), where the parking light and stop or parking and fog light are on one wire. In this case, connect the input of the position lamp and the input of the stop lamp to the cable on which both signals occur, or take information about the stop lamp from the third stop lamp.\u003c\/p\u003e\u003cp\u003eIn the version supporting the cut-off of parking sensors (PDC) - which is available at our other auction - you need to cut off the negative power pole from the PDC control panel and connect the white cable (on the side of the PDC), the device will control the PDC by feeding or losing weight.\u003c\/p\u003e\u003ch2\u003eRecommended for cars with an on-board computer.\u003c\/h2\u003e\u003ch2\u003eRequired if the car has a light failure indicator or so many lamps in LED technology.\u003c\/h2\u003e\u003ch2\u003eThe offered electric set also works with trailers with LED lighting\u003c\/h2\u003e\u003cp\u003e\u003cb\u003eSuggested connection:\u003c\/b\u003e\u003c\/p\u003e\u003col\u003e\n\u003cli\u003eDisassembly of the rear part of the upholstery in a way that will allow access to the rear lamps of the vehicle\u003c\/li\u003e\n\u003cli\u003eInstallation of the control panel in a dry and best invisible place\u003c\/li\u003e\n\u003cli\u003eConnecting the electrical harness to the device\u003c\/li\u003e\n\u003cli\u003eConnection of the control unit mass to the vehicle body\u003c\/li\u003e\n\u003cli\u003eConnection of input wires according to the scheme (next to)\u003c\/li\u003e\n\u003cli\u003eInformation from the Reversing light is connected in the case of mounting a 13 pin socket\u003c\/li\u003e\n\u003cli\u003eInstallation of the trailer socket and connection of wires according to the scheme (below)\u003c\/li\u003e\n\u003cli\u003eConnecting the power cord to the positive pole of the battery and inserting the fuse\u003c\/li\u003e\n\u003cli\u003eAll connections should be soldered and insulated or used for this purpose quick couplers,which are included.\u003c\/li\u003e\n\u003c\/ol\u003e\u003cp\u003e\u003cb\u003eThe installation of the device should be carried out by a specialized plant.\u003c\/b\u003e\u003c\/p\u003e\u003cul\u003e\n\u003cli\u003eWorks with CAN-Bus installation;\u003c\/li\u003e\n\u003cli\u003eWorks with LED and single-fiber lighting;\u003c\/li\u003e\n\u003cli\u003eFor connecting a 7 PIN socket;\u003c\/li\u003e\n\u003cli\u003eDetection of trailer connection;\u003c\/li\u003e\n\u003cli\u003e\u003cb\u003eE20 approval (available at the device control panel)\u003c\/b\u003e\u003c\/li\u003e\n\u003c\/ul\u003e\u003ch2\u003eFUNCTIONS OF THE MODULE\u003c\/h2\u003e\u003cul\u003e\n\u003cli\u003efog lamps - YES\u003c\/li\u003e\n\u003cli\u003ereversing lights - NO (other module available on our other auctions)\u003c\/li\u003e\n\u003cli\u003ebrake lights STOP - YES\u003c\/li\u003e\n\u003cli\u003eposition lamps - YES\u003c\/li\u003e\n\u003cli\u003edirection indicators - YES\u003c\/li\u003e\n\u003cli\u003etrailer module - YES\u003c\/li\u003e\n\u003cli\u003eCAN BUS - YES\u003c\/li\u003e\n\u003cli\u003ecooperation with parking sensors - NO (other module available at our other auctions supporting parking\/reverse sensors)\u003c\/li\u003e\n\u003cli\u003eapproval - YES, E20\u003c\/li\u003e\n\u003c\/ul\u003e\u003cp\u003e\u003cb\u003eThe ETK 7.01 electronic module is designed to connect the hook electrical system in cars where computer lighting control systems are used.\u003c\/b\u003e \u003cb\u003eIn such cars, direct connection to the rear lamps of the 7-pin trailer socket may result in damage to the on-board computer.\u003c\/b\u003e \u003cb\u003eThe use of the module does not constitute additional loads for the installation of the car, because each module input is characterized by a very low current consumption of 1mA.\u003c\/b\u003e \u003cb\u003eEach module output is protected against possible short circuits from the side of the trailer electrical system.\u003c\/b\u003e\u003c\/p\u003e\u003ch2\u003eSet Contents:\u003c\/h2\u003e\u003cul\u003e\n\u003cli\u003eControl unit\u003c\/li\u003e\n\u003cli\u003eElectrical harness 7.0 (ready-made connection harness with access to the control panel and exit to the socket)\u003c\/li\u003e\n\u003cli\u003eSocket 7 PIN\u003c\/li\u003e\n\u003cli\u003eRubber (seal)\u003c\/li\u003e\n\u003cli\u003eQuick couplers\u003c\/li\u003e\n\u003cli\u003eMounting screw, nut and washer\u003c\/li\u003e\n\u003cli\u003eClamp ties\u003c\/li\u003e\n\u003cli\u003eConnectors\u003c\/li\u003e\n\u003cli\u003eConnector Eyelet\u003c\/li\u003e\n\u003cli\u003eFuse 10A\u003c\/li\u003e\n\u003cli\u003eFuse holder\u003c\/li\u003e\n\u003c\/ul\u003e\u003cp\u003e\u003cb\u003eMODULE WORKS WITH VIRTUALLY EVERY CAR MODEL PRODUCED FOR THE EUROPEAN MARKET\u003c\/b\u003e\u003c\/p\u003e\u003cp\u003e\u003cb\u003eIN THE APPENDIX BELOW INSTRUCTIONS FOR CONNECTING THE MODULE WITH THE DIAGRAM !\u003c\/b\u003e\u003c\/p\u003e\u003ch2\u003eSpecifications\u003c\/h2\u003e\u003ctable\u003e\n\u003cthead\u003e\u003ctr\u003e\n\u003cth\u003eGroup\u003c\/th\u003e\n\u003cth\u003eName\u003c\/th\u003e\n\u003cth\u003eValue\u003c\/th\u003e\n\u003c\/tr\u003e\u003c\/thead\u003e\n\u003ctbody\u003e\n\u003ctr\u003e\n\u003ctd\u003eParametry\u003c\/td\u003e\n\u003ctd\u003eCondition\u003c\/td\u003e\n\u003ctd\u003enew\u003c\/td\u003e\n\u003c\/tr\u003e\n\u003ctr\u003e\n\u003ctd\u003eParametry\u003c\/td\u003e\n\u003ctd\u003eInvoice\u003c\/td\u003e\n\u003ctd\u003eWith a VAT invoice\u003c\/td\u003e\n\u003c\/tr\u003e\n\u003ctr\u003e\n\u003ctd\u003eParametry\u003c\/td\u003e\n\u003ctd\u003eKind\u003c\/td\u003e\n\u003ctd\u003e7 PIN\u003c\/td\u003e\n\u003c\/tr\u003e\n\u003ctr\u003e\n\u003ctd\u003eParametry\u003c\/td\u003e\n\u003ctd\u003eProduct weight with unit packaging\u003c\/td\u003e\n\u003ctd\u003e0.5 kg\u003c\/td\u003e\n\u003c\/tr\u003e\n\u003ctr\u003e\n\u003ctd\u003eParametry\u003c\/td\u003e\n\u003ctd\u003eEAN (GTIN)\u003c\/td\u003e\n\u003ctd\u003e5904569539207\u003c\/td\u003e\n\u003c\/tr\u003e\n\u003ctr\u003e\n\u003ctd\u003eParametry\u003c\/td\u003e\n\u003ctd\u003eManufacturer\u003c\/td\u003e\n\u003ctd\u003ePiAir\u003c\/td\u003e\n\u003c\/tr\u003e\n\u003ctr\u003e\n\u003ctd\u003eParametry\u003c\/td\u003e\n\u003ctd\u003ePackaging status\u003c\/td\u003e\n\u003ctd\u003eoriginal\u003c\/td\u003e\n\u003c\/tr\u003e\n\u003c\/tbody\u003e\n\u003c\/table\u003e","brand":"C4_com_pl-Alarmy","offers":[{"title":"Default Title","offer_id":54113529758043,"sku":"18263420951","price":58.66,"currency_code":"EUR","in_stock":true}],"thumbnail_url":"\/\/cdn.shopify.com\/s\/files\/1\/0954\/9355\/4523\/files\/Trailer-lighting-module-PiAir-ETK-7-01-Hook-module-set-7-PIN-Polish.jpg?v=1789740748","url":"https:\/\/homy.lt\/lv\/products\/priekabos-apsvietimo-modulis-piair-etk-7-01-7-kontaktu-lenkiskas","provider":"homy.lt","version":"1.0","type":"link"}