Automašīnas starta ierīce ar kompresoru 10 bar, 12V, 6000A JUMP STARTER


Cena:
Akciju cena€126,32
Noliktava:
Pieejams noliktavā

Apraksts

Trumpai apie prekę

Prekė: Automobilio paleidimo įrenginys su kompresoriumi 10 barų, 12V, 6000A JUMP STARTER. Kategorija: Paleidimo įrenginiai (boosteriai).

  • Gamintojas: FUMO
  • Modelis: FB60005R (Q10)

➡ Gain 100% self-sufficiency on the road and forget about the stress of a flat battery or flat tires!

Meet FUMO Q10 6000A – an uncompromising, new-generation emergency device combining a powerful 12V starting booster with a peak current of 6000A , a built-in 10 bar digital compressor with Auto-Stop function , a 60 cm cable and tip storage, an efficient 12000 mAh power bank and a bright LED flashlight .

There's nothing more frustrating than a car that breaks down on a winter morning when you're rushing to work or on a long trip.

With FUMO Q10 you regain full independence and peace of mind! The device starts petrol and diesel engines in a few seconds – even with a completely discharged battery (0V) .

The integrated digital compressor with Auto-Stop automatically inflates your car, bike or ball tire, and the built-in storage compartment ensures you always have all your accessories in place.

⭐ Key features:

✅ Starting current 6000A: Instant start of petrol and diesel engines – you start the car in 5 seconds without roadside assistance and looking for a second driver.

✅ BOOST forced start button (for aku 0V): Reviving completely “dead” batteries – you emergency start the vehicle even at zero voltage.

✅ Digital compressor 10 bar (150 PSI) with Auto-Stop: Automatic pumping of wheels to the set value without the risk of overloading the tire.

✅ Compressor cable 60 cm & Integrated storage in housing: Convenient access to the valve in any wheel position and no more losing needles or adapters.

✅ SMART clamps with a safe spacing of 58 cm: Full protection against sparking, pole and short circuit changes and free range under each mask.

✅ Powerbank 12 000 mAh (44 Wh) with high-speed USB-A port: Reliable power source on the go – instant charging for your phone, tablet and navigation.

✅ Super Bright LED headlight with 3 modes: Engine compartment lighting on the dark side of the road and SOS emergency signaling.

✅ Clear HD digital LCD display: Accurate preview of tire pressure, battery level in % and active modes.

When the battery in your car is extremely discharged in the cold, ordinary rectifiers and automatic devices will not detect the connection. FUMO Q10 solves this problem with a dedicated BOOST button.

✅ Forcing full starting power: Activating BOOST mode skips battery voltage detection and immediately activates the start function.

✅ Safe cable spacing 58 cm: The length of the positive cable [+] is 30 cm, and the negative cable spacing is 30 cm, which provides a total spacing of 58 cm. This allows you to freely attach the blade to distant mass points in any car.

✅Instant diagnosis and start: After activation, the forced start function prepares the device to supply electricity, giving you 30 seconds to turn the key in the ignition and start the vehicle without the help of strangers.

➥ This is ideal in emergency situations, on the road and in winter – when immediate response and reliability are important.

➡ Built-in Digital Compressor 10 bar with Auto-Stop Function – Zero Stress on Tyre Pressure 💨

Lack of air in the wheels on the route is not only a risk of damage to the rim, but also a huge danger. FUMO Q10 has an efficient integrated digital compressor with a pressure of up to 10 bar (150 PSI).

✅ Pumping without looking for a station: Quickly and effortlessly replenish the tire pressure of your passenger car, van, SUV, motorcycle or bike – anywhere, anytime.

✅ Intelligent Auto-Stop Sensor: You set the desired pressure on the HD digital LCD screen (in BAR or PSI). The compressor pumps the tire and automatically stops working when the designated level is reached.

✅ Improved piston engine: Efficient design allows you to efficiently inflate the wheel in several dozen seconds, saving you time and effort.

➡ Compressor Cable 60 cm & Integrated Tip Storage – Order and Convenience

The biggest bane of traditional push-ups are too short hoses and small needles and adapters lost at the bottom of the trunk. FUMO Q10 solves this problem 100%.

✅ Long pressure hose 60 cm: Provides a comfortable connection to the tire valve regardless of whether the valve has stopped at the bottom or at the very top of the wheel.

✅ Integrated storage compartment in the housing: In the housing of the device there is a dedicated, lockable box for needles and adapter tips. You always have a set of 4 adapters at hand!

✅ Versatility: The included set allows you to instantly inflate bicycle wheels ( Presta/DV valve), sports balls, camping mattresses and beach toys.

➡ Powerful Powerbank 12 000 mAh (44 Wh) with USB-A Port – Energy Reserve for Your Phone

An unloaded phone during a breakdown on the road is an additional stress and the inability to call for help. FUMO Q10 acts as a mobile power bank.

✅ Capacity 12 000 mAh (44 Wh / 3.7V): The energy supply is enough for 2 to 3 full charges of a modern smartphone (real available output capacity at 5V USB is approx. 7 830 mAh with 89% efficiency of the converter).

✅ High-speed USB-A output port: Allows you to quickly renew the battery on your phone, GPS navigation, car camera or TWS headphones.

➡ Super Bright LED Headlamp with 3 Modes – Visibility and Safety after Dark

Working on the engine or replacing the wheel in the dark without the right light is extremely difficult and dangerous. FUMO Q10 is equipped with a powerful LED headlight.

✅ 3 functional light modes:

  • Continuous mode: Powerful light accurately illuminates the entire engine compartment or wheel when pumping.
  • Stroboscope Mode: Dynamic flashes attract attention and alert other traffic participants.
  • SOS mode: Broadcasting emergency signals on an unlit roadside.

✅ Independent start-up: You turn on the flashlight with a convenient button, thanks to which the device serves as an efficient light source under the tent and in the garage.

➡ Easy-to-read HD LCD Display & Armored Housing – Full Control in Difficult Conditions

Instead of illegible, blinking LEDs, the FUMO Q10 offers a precise digital screen and a durable housing ready for difficult treatment.

✅ HD LCD Display: Shows the exact battery level as a percentage (0 to 100%), current tire pressure and active security icons.

✅ Reinforced composite housing: Resistant to shocks, drops and scratches when stored in the trunk or car glove compartment.

✅ Compact and handy design: Despite its enormous power, the device easily fits in your hand, backpack or car glove compartment.

➡ Safe to use – lithium polymer (Li-Po) cells and 8 levels of protection 🛡

The safety of your vehicle's electronics is a priority. The FUMO Q10 uses stable high-density lithium-polymer (Li-Po) cells and SMART cables equipped with a digital LCD voltmeter.

✅ Durable and stable Li-Po cells (44 Wh / 12 000 mAh): Unlike traditional batteries, polymer cells are distinguished by higher shock resistance, voltage stability under high load and no risk of electrolyte leakage.

✅ 8-stage processor protection: Advanced klem controller protects against pole changes (reverse polarity), short circuit, overcurrent, overheating, overcharging, deep discharge, reverse current and spark.

➡ Can work in all conditions – resistance to winter and summer (-20°C to +60°C) 🌡

Whether you are struggling with sulphurous frost in the middle of winter or with the hot summer sun, the FUMO Q10 retains 100% operational efficiency.

✅ Safe start-up in winter (-20°C) ❄ : The special formula of the Li-Po cell electrolyte prevents a drastic drop in voltage at minus temperatures, allowing you to start the car even after a cold night in a snowy parking lot.

✅ Heat resistance (+60°C) ☀ : Reinforced housing made of fire-resistant ABS+PC plastic and NTC thermal protection protect the device from overheating in a heated car during the summer.

➡ Ready-made Premium Kit with FUMO 3A Charger in Hard EVA Case – Perfect for Storage and Trunk

No more searching for loose cables all over the trunk. The FUMO Q10 comes in a complete, elegant and hardened EVA transport case.

  1. Starting device 6000A
  2. SMART cables
  3. Compressor cable.
  4. USB cable.
  5. 4 x Compressor tips.
  6. Hard case.
  7. User manual in Polish.
  8. Charger Fumo®

⚙ Technical parameters of FUMO Q10 6000A

  • Peak Current: 6000 A
  • Supported installations: 12V (Gasoline and Diesel engines up to 5L)
  • Forced BOOST function: Yes (button on the klem module for aku 0 V)
  • Maximum compressor pressure: 10 Bar / 150 PSI (with Auto-Stop function)
  • Compressor cable length: 60 cm (reinforced pressure hose)
  • Storage compartment for pumping accessories: Yes (integrated box in housing with 4 tips)
  • Battery rated capacity: 12 000 mAh / 44 Wh (at 3.7V DC)
  • USB Output (Powerbank): 1x USB-A (for charging phones)
  • Device charging input: 1x USB-C Input ONLY
  • SMART jumper cable spacing: 58 cm (cable length [+] 30 cm, [-] 30 cm)
  • Microprocessor protection: NTC, reverse polarity, short circuit, spark
  • LED Flashlight: Super Bright Reflector (3 Modes: Continuous, Strobe, SOS)
  • Display: Digital LCD HD (battery level, BAR/PSI pressure)
  • Dimensions: 20 x 11 x 5 cm
  • Weight: 740g
  • Safety Certificates: CE, RoHS

➡ How to properly use the booster with the FUMO Q10 compressor?

⭐ First charge of the device: After purchase, charge the booster to 100% from the USB charger. For optimal lithium cell life, recharge the device once every 3 to 4 months during non-use.

⭐ Correct use of BOOST:

If the battery in the car is completely discharged (0V), connect the SMART clamps to the poles, press and hold the BOOST button on the module for 3 seconds (the green LED will light up permanently) and start the motor within 30 seconds.

⭐ Use of compressor:

Connect the 60 cm hose to the tire valve, set the desired pressure on the LCD screen and turn on the pumping. When finished, hide the compressor adapters into the built-in locker in the housing to avoid losing them.

⭐ Protection against frost and heat:

Do not leave the device in a heavily sunlit car in hot summer. Before starting in the cold, warm the booster in your hands or inside the jacket for a minute.

➡ FAQ – Answers to the most important questions

2. When should I use the BOOST button?

The BOOST button is used for forced start in situations where the car battery is completely discharged (voltage drops to 0V) or we have a problem with starting in normal mode. After connecting the klem, press the BOOST button on the module for 3 seconds until the green LED lights up, and immediately start the engine.

3. Where are the tips for pumping balls and mattresses?

The device has an integrated storage compartment built directly into the housing. Simply open the box to remove a set of 4 brass and composite adapters.

4. What is the range of the boot clam?

SMART starter cables have a spacing of 58 cm (positive cable 30 cm, negative cable 30 cm), which guarantees trouble-free reaching to mass points in most engine chambers.

5. Why is the weight of the device itself 730 g?

A huge package of dense 44Wh (12 000mAh) Li-Po cells, copper current rails and a powerful compressor motor weigh exactly as much as high efficiency requires. The weight of 730 g is a guarantee of reliable technical parameters and the highest durability.

6. What to do in case of problems with starting the vehicle with a booster (e.g. 2.0 TDI diesel engine or 0V battery)?

The peak current of 6000 A has a huge power reserve. If the car does not start anyway, 99% of the time it is due to minor connection errors or failure to activate Safe Mode. Just follow these steps:

1 Use the BOOST button with a deeply discharged battery (0V): When the factory battery in the car is fully discharged, the SMART clam protection system will not detect it automatically and will not supply electricity. Connect the clamps (+ red to plus, - black to minus/mass), then press and hold the BOOST button on the klem module for approx. 3 seconds until the green LED lights up with continuous light. From now on, you're okay. 30 seconds to start the engine.

2 Provide ideal klem contact to metal (pole cleaning): Copper klem teeth must adhere directly to a clean metal battery post or mass point. Remove tarnish, oxide or rust and make sure the clamps do not fasten on the plastic housing or loose wire.

3 Wait for the glow plugs (diesel engines) to go out: On cold days after turning on the ignition, wait 2 to 3 seconds until the yellow spiral of glow plugs on the dashboard goes out, and only then spin the starter (turn max. for 3 to 5 seconds).

4 Check the booster charge level: For efficient start-up of difficult power units, the booster should be charged at a minimum of 50 to 75% (100% recommended).

5 Keep a distance between tests: If the engine does not start the first time, wait approx. 1 to 2 minutes before the next attempt to cool the NTC cells and protection system.

Specifications

Group Name Value
Parametry Condition new
Parametry Invoice With a VAT invoice
Parametry Brand FUMO
Parametry Battery capacity 12000 mAh
Parametry Model FB60005R (Q10)
Parametry Nominal voltage 12 V
Parametry Manufacturer code URZĄDZENIE ROZRUCHOWE booster z Kompresorem
Parametry Product weight with unit packaging 1 kg
Parametry EAN (GTIN) 5907046221510
Parametry Certificates of conformity CE
Parametry Batteries included yes

Precīzs piegādes termiņš norādīts augstāk un tiek aprēķināts katrai precei individuāli. Piegāde klientam ir bez maksas.

Saistītās preces

Nesen skatītās