Dvikanalė radijo linija ELMES U2HS, 11–17V DC, imtuvas su 2 siųstuvais DWB100HT

Trumpai apie prekę

Prekė: Dvikanalė radijo linija ELMES U2HS, 11–17V DC, imtuvas su 2 siųstuvais DWB100HT. Kategorija: Išoriniai moduliai.

• Gamintojas: Elmes
• Modelis: U2HS Radiolinia dwukanałowa 11...17V=DC

Set:

U2HR - radio receiver

DWB100HT - radio remote control - 2 pieces

The device is used in systems: remote control, access control, alarm systems and many others.

It can be used to switch on systems: controlling motors, lighting, electric strikes, releasing gate locks, doors,

switching on time corpses, as a wireless anti-pad button, etc.

Universal superheterodyne unichannel radioline U2HS for remote control with a range of up to 100m in open area.

Alarm transmissions are dynamically encoded in the KEELOQ® system, ensuring the highest level of security.

The receiver tracks these changes and only responds to new code.

Codes once used are not accepted. This prevents the intercepted codes from being reused.

Receiver operating modes :

The receivers have galvanically separated relay outputs with programmable operating mode, signal output and 2 light-emitting diodes.

The receiver housing is protected by an anti-tamper switch.

Specification:

Possibility to assign any remote control buttons to any receiver outputs

1. Some one-button remote controls output No. 1, and another - output No. 2.

2. One remote control button turns on both outputs at once.

3. One button of the remote control turns on the output, and the other - turns off.

4. Any button of the four-button remote control CH4HT turns on output 1, and any other - output 2.

Different modes of operation of receiver outputs

Each receiver output can work in one of many modes:

1. The remote control switches on the output for the programmed time. Pressing the remote control again extends the switching time.

2. The remote alternately turns the output on and off.

3. The remote control switches on the output for the programmed time, but it is possible to turn off the remote earlier.

4. The remote alternately turns the output on and off (like mode 2), but when one output is on, the other cannot be turned on.

5. Like mode 3, but when one output is included, you cannot turn on the other.

6. The output is included as long as the remote is pressed.

7. One button of the remote control turns on the output, and the other - turns off.

The receiver has two LEDs.

The top LED lights up green when output 1 is on and red when it is off.

The bottom LED lights up green when output 2 is on, not on - when off.

The receiver has an open collector output with a load capacity of 1A/60V (marked with the letter “S”),

which signals the moments when each output is switched on and off. It also signals the remote control button.

• KEELOQ® variable code system. Microchip Corp. USA
• pilot memory: 104
• radio receiver superheterodyne, sensitivity: -106 dBm
• Current consumption: 20mA + 20mA for each included relay
• Operating temperature: from -20°C to +50°C
• load capacity of relay outputs: 1A/120VAC/30VDC
• 11...17VDC power supply
• 2 output modes: 1 - monostable = output switching time from 0,25 sec. up to 4 hours / 2 - bistable = on/off
• output S (1A/60V) type "open collector"
• anti-sabotage output of housing opening signalling, type NC (compact with closed housing) used in alarm systems
• dimensions in mm: 24/46/73

• operating frequency 433,92MHz;
• power 3-5mW;
• range in open area approx. 100m
• 23A 12V alkaline battery - included
• dimensions (L/W/H) 50/37/14mm.

ALL RADIOLINES of the ELMES brand and other products are in adjacent auctions.

Specifications