Piegādes termiņš visā Lietuvā: 5-7 darba dienas.
Piegādes cena uz norādīto adresi: 3 eiro
Apraksts
Trumpai apie prekę
Prekė: Nešiojamas garų inhaliatorius, plastikinis, pagamintas Vokietijoje. Kategorija: Inhaliatoriai.
- Gamintojas: no brand
- Modelis: Dr. Junghans Medical GmbH
- Spalva: white
It is a device that supports respiratory health. It is used to carry out hot steam inhalation with the addition of selected medical devices or medicines. This allows you to quickly control infectious runny nose or allergic reactions.
The Kunststoff inhaler is a very easy device to use. It consists of two folding parts and a mouthpiece. The inhalation procedure can be done in just a few minutes. No connection to the power supply is required, so the inhaler will work everywhere – also on a trip, especially if there is a risk of hay fever and swelling of the mucous membranes.
The Kunststoff inhaler allows you to easily and effectively carry out an inhalation that relieves most upper and lower respiratory ailments.
Use as intended.
To avoid inhaling too hot fumes, at the beginning of use, gradually and carefully bring the nose closer to the hole.
Pour the liquid to a maximum of half the height of the tank.
Avoid moving the inhaler after filling it with hot water. Use the handles on the sides of the inhaler to hold the inhaler.
Do not leave the inhaler unattended. Children should only use the inhaler in the presence of an adult. A blow or tilt can cause hot fluid to escape from the inhaler, which can lead to burns.
Before each use, check that there is no external damage.
Please read the instruction manual and hazard warnings carefully before use.
Remove the inhaler from the pack. Place the lower part on a flat, heat-resistant surface, approximately at the height of the table. Fill it with hot water (max. 90°C), then add the solution for inhalation or fill the device with a ready-to-use solution. Apply the top to the bottom and turn it clockwise until the latches click. Always make sure that the top is well seated. Now you can start the inhalation process. After its completion, separate the upper and lower parts, turning them counterclockwise. Clean them.
Specifications
| Group | Name | Value |
|---|---|---|
| Parametry | Condition | new |
| Parametry | Invoice | With VAT invoice |
| Parametry | Brand | no brand |
| Parametry | Medical device | yes |
| Parametry | Medical device type | medical device or in-vitro diagnostic medical device |
| Parametry | Manufacturer of a medical device | Dr. Junghans Medical GmbH |
| Parametry | Kind | other |
| Parametry | Color | white |
| Parametry | Power supply | none |
| Parametry | EAN (GTIN) | 4061923002683 |
| Parametry | Model | Dr. Junghans Medical GmbH |