Sidabrinės nano dalelės generatorius

Trumpai apie prekę

Prekė: Sidabrinės nano dalelės generatorius. Kategorija: Mobilūs oro kondicionieriai.

• Gamintojas: no brand
• Modelis: GSK-2 GREEN
• Galia: 0 W

Promotional offer for microprocessor colloidal silver generator GSK-2 GREEN (30V, approx. 3,5mA, version for 4 electrodes).

High quality colloidal silver production. Colloidal silver (nanosilver) has disinfectant properties. Reusable silver masks can be soaked to increase the effectiveness of protection.

Included:

1. Generator GSK-2 GREEN

2. 9V or 12V power supply

3. Banana plugs 4pcs

To produce high quality colloidal silver best:

1. Use silver wires with a minimum sample of 999. Wires must be purchased separately.

2. Ultrapure distilled or demineralized water with a maximum content of foreign ions of 2ppm must be used for the production of colloidal silver. Do not use tap water, mineral water, etc. Good water includes distilled Kamix and demineralized Aqua Tech from Orlen (available at Orlen petrol stations).

3. As dishes, it is best to use glass or ceramics. Metal vessels are not allowed.

4. Electrodes must not touch the bottom and walls of the vessel. The vessel must be clean.

5. It is best to use a TDS meter to control the purity of water and the final concentration.

6. Do not mechanically mix the colloid during the manufacturing process.

7. Recommended what ok. 2-3 hours cleaning electrodes from sediment (dark gray sediment) with kitchen towel, hygiene wipe, cotton towel, etc.

8. Produce in a dark place at room temperature. Permissible heating during the process. Not allowed in a sunny room.

9. Every dozen liters it is recommended to sand silver wires with fine sandpaper to shine

10. Store colloidal silver in a dark glass dish in a dark place at room temperature.

Main features of the generator

• Current limitation - approx. 3,5mA
• Maximum output voltage - 30V
• Electrode spacing - approx. 5cm
• Change in electrode polarity
• Automatically lowering the voltage on the electrodes with current limitation
• Generator designed for silver electrodes from 2 to 2,5mm in diameter and from 10 to 15cm in length
• Typically, the generator is capable of producing up to 15ppm at full immersion or 20-25ppm at incomplete electrode immersion.
• The speed of production is ok. 1ppm per 1-2 hours depending on the amount and purity of water and the size of the wires.

Description of colloidal silver generator GSK-2 GREEN

• power supply in the range of 9-12V DC. 9-12V power supply included.
• Power consumption approx. 70mA. Power consumption ok. 0,8W.
• protection against short circuit of electrodes
• overload protection
• set the threshold for the function of the end of the process from the voltage prevailing on the silver electrodes of the colloid. Well, for current limitation when increasing the concentration of SK, the microprocessor lowers the voltage. For a specific concentration and set threshold (on the potentiometer) the process will be completed. The process completion signal is pulsing (liquid) LEDs. The closer to completing the process, the faster the LED will flash. If the concentration is too low, turn the potentiometer to the right. If the concentration is too high, turn left. Similar concentrations will be obtained for the same vessel and the same amount of water. For example: for the middle position of the potentiometer and for a glass of water, the concentration of SK approx. 7-12 ppm
• change of polarity fully electronic. The change time is set permanently and is approx. 1 minute.
• dimensions in the housing 9,5cm by 5cm. Height 4cm.

Manufacture of colloidal silver

For a clean dry dish e.g. jar of 0,9 liters pour approx. 800ml ultrapure water. Place the generator on the dish so that the electrodes are as submerged as possible. Do not flood the plugs.

Connect the power supply to the mains. Manufacturing can take several hours. During the process, the LED flashes. Closer to the end, the LED flashes faster. As the diode pulsates (dimmes and brightens within approx. 1s) is the generator disconnected the voltage from the electrodes and will not do more concentration. Check the concentration with the TDS meter.

During production, it is recommended to clean the electrodes.

If too small, disconnect and reconnect the power supply so that the timer in the generator resets. Generator designed for the best quality and typically produces up to 15ppm. The best quality of produced colloidal silver is between 5 and 15ppm.

During the production, the electrodes will be covered with gray sediment (silver oxides).

After the process is complete, filter the colloidal silvers well (e.g. through a coffee filter) to get rid of sediments. The appearance of sediments is correct.

Electrodes should evenly overlap with gray sediment.

Specifications