Termometras su ekranu ir garsu signalu TA1/2

Trumpai apie prekę

Prekė: Termometras su ekranu ir garsu signalu TA1/2. Kategorija: Jutikliai.

• Gamintojas: no brand
• Modelis: TERMOMETR Z WYSWIETLACZEM I ALARMEM TA1 /2

THERMOMETER WITH LOUD SOUND BEACON (85dB max)

The thermometer equipped with a sensor on the cable 1 meter shows the current temperature.

.

Typically , after exceeding the upper limit temperature (switching temperature), a loud alarm is activated - an intermittent signal.

However, the game temperature will drop below the lower limit temperature (off temperature) - the alarm will be turned off.

For example, by setting the switching temperature under the ▲ button to 40°C and the switching off temperature under the ▼ button to 35°C, the alarm will turn on when the temperature rises to 40°C and turn off after cooling to 35°C. The LED display shows the current temperature. The thermostat, of course, remembers the settings when the power is disconnected.

.

You can also set the reverse action - then the beacon will turn on when the temperature drops BELOW the switching temperature and turn off when the temperature rises above the switching off temperature. In this case, simply set the ▲ switching temperature lower than the set switching off temperature (with the ▼ button).

The set consists of:

1. 12V DC Plug-in Power Supply
2. Electronic thermostat
3. thermostat temperature sensor
4. sounder (buzer)

.

Wire lengths indicatively:

• cable from power supply to thermostat (1-->2) about 140cm
• temperature sensor cable (2-->3) about 100cm
• output cable for buzzer (2-->4) about 110cm

Set data:

• Power Supply: 12V (Power Supply Included)
• Measurement range: -20°C to +100°C
• The diameter of the buzzer approx. 3cm
• The thermostat indications are approximate, close to the actual temperature.

.

Setting the switching on and off temperature is very simple (mode: switching on the alarm above the set limit temperature):

• After holding down the ▲ button, we set the switching temperature (the set temperature will start flashing - after setting it, wait a few seconds to save the setting)
• After holding the ▼ button, we set the shutdown temperature (it must be lower than the switching temperature), (the set temperature will start flashing - after setting it, wait a few seconds to save the setting)
• LED (OUT) next to the temperature display signals the buzzer to be switched on
• Always use the difference (hysteresis) between the set switching on and off temperature (minimum 1-2 °C) - small hysteresis causes frequent switching on / off of the buzzer, which adversely affects the thermostat and the beacon.

Specifications