Baseino dulkių siurblys robotas BLOSSOM S2 ULTRA, automatinis dugno valymas

Trumpai apie prekę

Prekė: Baseino dulkių siurblys robotas BLOSSOM S2 ULTRA, automatinis dugno valymas. Kategorija: Dulkių siurbliai.

• Gamintojas: Blossom
• Modelis: blossom-s2-ultra
• Galia: 40 W

⭐BLOSSOM S2 ULTRA Wireless Pool Vacuum Cleaner Robot - 40W Ground Pool Vacuum Cleaner, Dual Cleaning System, Working Time 120 Minutes (Up to 1614M²), Suitable for Ground and Indoor Pools⭐

💧【Suction power 40 W】:

• Unleash the Unparalleled Power of Cleaning! This pool vacuum cleaner is equipped with a suction nozzle with a diameter of 2,5 cm (1 inch) and a high-efficiency water purification system of 3000 GPH (3000 GPH), removing 2 times more impurities, 3 times more leaves and 8,5 times more sand.

💧【Double Cleaning System】:

• The dual cleaning system of the pool vacuum cleaner combines a mesh of 180 μm to capture leaves, twigs and larger debris. A layer of cotton sponge captures fine particles such as sand and silt. Increase cleaning efficiency by 50%

💧【Up to 120 minutes of operation】:

• This automatic pool vacuum cleaner offers a battery life of up to 120 minutes, covering an area of up to 1614 square meters.
• One charge is enough to clean the entire pool.

💧【Excellent ability to overcome obstacles】:

• This ground level pool vacuum cleaner easily overcomes unevenness and drains with a width of 0,2 inches (about 0,2 cm) and overcomes hills with an inclination of up to 15 degrees, ensuring thorough cleaning on different types of pool.
• It should be remembered that the performance may decrease slightly with the accumulation of impurities inside, so it is recommended to regularly clean the pool vacuum cleaner at ground level.

💧【 Anti-pollution retreat system】:

• This pool vacuum cleaner features an improved water drainage system that ensures all collected debris stays inside while draining the accumulated water within seconds of its removal from the pool.

📢❗❗Usage Tips

• 📌1. To avoid scratching the pool, set the bottom of the vacuum cleaner towards the pool.
• 📌2. How to use the sponge filter: a. If algae or fine particles in the pool cannot be effectively filtered out, place it in a dust container to increase filtration efficiency. b. After use, the filter can be cleaned manually. Do not use excessive force or rinse with a water gun to avoid damaging the filter. c. Sponge filter is a consumable; damage after repeated use is normal.
• 📌3. Prepare the appropriate hose and connect the hook to remove the device from the water. The inner diameter of the fuse must be 1 to 1/4 inch (3,5 mm).
• 📌4. When installing the top cover and base, pay attention to the installation direction shown in the diagram below. The pin marked with an arrow must be aligned with the hole near the base clamp. ❗❗Note: First locate the two holes in the base clamp. Make sure that the pin in the upper lock position is aligned with the hole. Otherwise, the clamp may be damaged.
• 📌5. Do not place the base screen up while charging.
• When charging, remove the silicone cap and wipe the inside of the interface or metal pins to remove water and debris. Once charging is complete, press the silicone cap firmly to prevent water from entering the charging port.
• You can use the included hook to remove the product normally. Do not pull on decorative silicone elements after removing the product from the water.
• 📌6. After use, turn off the robot vacuum cleaner.
• 📌7. When the robot vacuum enters or exits the pool, do not touch the pool walls to avoid scratching the pool walls or damaging the pool.
• 📌8. Wait a while (10 to 15 seconds) for the robot to drain the accumulated water, then remove it from the water.
• 📌9. When the battery is finished cleaning or discharged, the robot will automatically dock at the edge of the pool.
• 📌10. Attach the included hook to the pool bar, clean the robot grip parts, and then remove it from the water.

📦📦📦📦📦

✔ Specification

• Product Name: S2 Ultra Pool Cleaning Robot
• Product model: BLOSSOM S2 ULTRA
• Rated Power: 40 W
• Charger input: 100-240 V~50/60 Hz
• Charger output: 25,2 V = 1,0 A
• Water filtration: 26 GPM/100 LPM
• Filtration efficiency: Nylon 240 μm + sponge
• Speed: 59 feet/minute
• Waterproof: IPX8
• Product Dimensions: 388 x 405 x 107 mm
• Storage temperature: -30°C to 65°C
• Operating temperature: 0°C to 40℃
• Working time: 120 minutes
• Waterproof: IPX8

✔ Contents of the pack:

• Pool Cleaning Robot S2 Ultra *1
• Power supply *1
• User manual *1

Specifications