Pristatymo terminas visoje Lietuvoje: 5-7 d.d.
Pristatymo kaina nurodytu adresu: Pristatymas nemokamas
Aprašymas
Trumpai apie prekę
Prekė: Storos 3,3 m 1200A varinės automobilio užvedimo laidai benzininiams ir dyzeliniams varikliams. Kategorija: Užvedimo laidai.
- Gamintojas: no brand
- Ilgis: 3.3 m
Robust 1200A jumper cables with a length of 3,3 meters are practical equipment for the car in case of a discharged battery. The long cord makes it easy to connect two vehicles, and the strong clamps allow you to conveniently connect the wires to the battery.
The cables are made of copper and the whole set weighs 1,6 kg. The kit is designed for both gasoline and diesel vehicles.
The set comes in a practical case with a handle for hanging, so the wires can be conveniently stored in the trunk, garage or workshop.
⭐ THE MOST IMPORTANT ADVANTAGES
- Intensity: 1200 A
- Length: 3,3 meters
- Copper Cables
- Set weight: 1,6 kg
- Thick and robust jumper cables
- Designed for gasoline and diesel engines
- Long, 3,3-meter cable for easy positioning of vehicles
- Robust terminals for the battery
- Red and black wire for easy connection
- Practical storage case
- The handle in the case allows you to hang the set
- Ideal for car, garage, workshop and van
⚡ 1200A – HIGH STARTING POWER
1200 AMP starter cables will work as emergency equipment for the car, especially in winter, when low temperature increases the risk of problems with starting the vehicle.
This is a solution for drivers looking for thick, robust 1500A jumper cables, instead of short wires with a small cross-section.
📏 UP TO 3,3 METERS LONG
3,3 m starter cables provide great freedom when connecting the car to the donor vehicle.
The length of 3,3 meters can be particularly convenient in the parking lot, driveway or garage, where it is not always possible to position cars very close to each other.
🔩 COPPER CABLES
The use of copper provides conductors with good electrical properties. Combined with solid clamps, you get a practical kit designed for emergency starting of a vehicle with a discharged battery.
🚗 PETROL AND DIESEL
The cables are suitable for vehicles equipped with gasoline and diesel engines.
They can be equipped with m.in. A passenger car, SUV, VAN, bus or van – the cables should always be selected according to the requirements of a specific vehicle and battery.
⚡ HOW TO CHOOSE JUMPER CABLES?
Approximate selection according to intensity:
Approximate application for 400 A scooters 600 – 800 A small petrol cars 900 – 1000 A SUVs, VANs, Diesels from 1200 A buses, vans 1500 A – this set is a powerful set for demanding applications
The selection of cables should also take into account the battery parameters, engine capacity and type, and the recommendations of the vehicle manufacturer.
Before use, check the instruction manual for both cars – some vehicles have designated special starting points.
- Turn off the ignition and electrical receivers in both cars.
- Connect the red terminal (+) to the positive pole of the discharged battery.
- Connect the second red terminal to the plus (+) of the working battery.
- Black terminal (–) connect to the minus of a working battery.
- Connect the second black terminal to the mass point indicated by the manufacturer in the vehicle with a discharged battery, away from the battery.
- Start the car with a working battery, and then try to start the second vehicle.
- Once started, disconnect the wires in reverse order, preventing the terminals from coming into contact.
Important: Do not use damaged wires or clamps. Maintain proper polarity and follow the vehicle manufacturer’s instructions.
After use, the wires can be rolled up and tucked into the included jumper cable case.
The handle allows you to hang the set, e.g. on the wall of the garage or workshop. The case also helps to keep the wires organized while transporting them in the trunk.
📋 SPECIFICATION
Product Starter cables Intensity 1200 A Length 3,3 m Conductor material copper Weight 1,6 kg Gasoline engines Yes Diesel engines Yes Packaging Etui Possibility to hang case Yes Cable color Red / black
Specifications
| Group | Name | Value |
|---|---|---|
| Parametry | Condition | new |
| Parametry | Invoice | With a VAT invoice |
| Parametry | Length | 3.3 m |
| Parametry | Amperage | 1200 A |
| Parametry | Product weight with unit packaging | 1.4 kg |
| Parametry | EAN (GTIN) | 5905629432032 |
| Parametry | Manufacturer | no brand |
| Parametry | Packaging status | original |