Vandens slėgio stiprintuvas, 24V, 150W, automatinis, buitinis

Trumpai apie prekę

Prekė: Vandens slėgio stiprintuvas, 24V, 150W, automatinis, buitinis. Kategorija: Siurbliai.

• Gamintojas: no brand
• Modelis: amagogo-53096591
• Galia: 0 W

BATHROOM PUMP FOR SHOWER BATHTUB WASHBASIN 150P AUTOMATIC 32L/min

This automatic pump for shower, bathtub, washbasin and other sanitary facilities ensures high efficiency and reliability. With a capacity of 32 liters per minute and a pressure of 22 meters, it's the perfect solution for any home.

Description:

[Assist pump]: 24V power supply, increasing water pressure, various scenarios can be done in 1 machine. Size 12,5 cm x 9 cm x 14 cm / 4,92 inch x 3,54 inch x 5,51 inch.

[Permanent brushless motor]: high power, low noise, stable operation, energy saving and environmental protection, long-term operation, extended service life.

[Waterproof]: The quiet, automatic 24V supply water pump is durable in operation and does not cause harm to the human body. Waterproof material, high efficiency and low noise.

[Automatic]: Turn on the faucet, start/turn off the faucet and stop the water pump.

[Application]: Mini automatic booster pump is used to increase the water pressure in bathroom showers in households, hanging booster boilers, spray boilers and smart toilets, etc. It can also loosen water in the kitchen, utility water and bathroom to increase water pressure.

✅Technical parameters:

• Item Type: MT24-150
• Power: 150 W
• max. flow rate: 25 l/min
• Pressure: 22 meters
• max. water temperature: 65°C
• Protection rating: IPX58
• Material: ABS, Brass
• Voltage:DC - 24 V
• Nominal diameter: DN15
• Power: 150Pa
• Sound noise：bass
• Manual mode：Manual/automatic mode
• Insulation class：Class H
• Power supply: 24 V DC power supply, 3 to 6 A
• Ambient temperature:0 to 40°C
• Medium temperature:4 to 95°C
• Medium requirements: clean, rare, non-corrosive, non-flammable and non-explosive, without particulate matter.

The properties of the liquid medium should be similar to those of pure water.

1: Glue nano adhesive tape on the back of the pump, then attach the pump to a smooth wall (if the wall is rough, use screws).

2: The installation bellows at the inlet and outlet can be rotated and tightened.

3: Connect the power supply. Press the “Start” button to start the pump. Press the “Turn off” button to turn off the pump. The pump goes into standby mode. There are two operating modes: manual mode and automatic mode. Do not use manual mode in case of water shortage to avoid damage to the pump.

✅List of packages:

• 1 x Booster Pump
• 1 x Power Supply
• 2 x Anchor
• 1 x Water Pipe
• 1 x No Punch Sticker

Directly install and use.

Specifications